To remove door panels (front or rear on a 4 door), open the door.
Remove (unscrew) the door lock button
Remove the inside window frame (garnish) by removing all of the screws, then
pull the upper portion out toward you and lift
Remove the two large Phillips head screws holding the arm rest on the door and
remove the armrest
Remove the two large Phillips head screws holding the arm rest holder on the door
Remove the arm rest holder
Remove all screws from around the edge of the door panel
Using a special "forked" tool, slide the tool between the door handle and the white
plastic washer and force the snap ring out of its seat. Remove the door handle
being careful not to lose the snap ring (you can clip in back into the door handle
and leave it there at this point
Repeat the above process with the vent window crank and the main window crank
(If appropriate)
Gently pull the door panel loose on the top and the sides. Grasp the panel and
gently lift up and out of the track on the bottom of the panel
Reverse the process to reinstall the panel.
Chevrolet 1955, 56 and 57, Passenger car and Sedan Delivery will interchange with your 4 door 57.
FORD
The length of a 1957 Chevrolet Bel Air 2 door sedan from bumper to bumper is 200 inches.
yes the 57 2 door hard top converttble was made yes the 57 2 door hard top converttble was made
Same door as the 55-57 Chevy that are reproduced. Best bet eBay them.$100-$300 each based on the body style 4 door sedan about $50.00
18463572...
about 75$
first you take of the top of the seat then you get your new material and stale it on the you sow it toughter and remove the staplesyour welcome n-i-g--g-a
The sexiest cars are the 57 Chevy belair and the 70 Chevy chevelle. HANDS DOWN.
15 gallons or 57 liters.15 gallons or 57 liters.
57"
American Hot Rod - 2004 '57 Chevy Part 1 was released on: USA: March 2007