0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you use paint thinner to remove linseed oil from metal?
Denatured alchohol will remove the dried linseed oil from metal, just don't get it on any wood.
How do you remove dry oil based paint from concrete?
Pressure washing is the best option.
Why is it recommended to change the transmission oil?
To remove contaminates (metal filings, dirt etc.)
Ways of preventing rusting?
covering the metal with varnish, paint or oil. keeping the metal dry will help your rusting problems!
How do you Remove hot oil stains on marble bench top?
You can remove hot oil stains on a marble bench top by washing it with very hot water and a good quality dish soap. Dry the bench top with a clean, dry towel to prevent smearing.
How do you remove oil injection line from carburetor of a kfx 80 fourwheeler?
It is held on by a small metal clip. Remove the clip and pull the injector out.
What is the physical change of metal if in contact with dry ice?
The metal would tend to contract in size. One technique to remove a gear from a shaft is to cool the shaft while heating the gear. The shaft contracts a bit while the gear expands a bit which can make the gear easier to remove. Also, dry ice (CO2) would not oxidize metal as water ice (H2O) would.
If the oil is full but the valve train is dry and noisy on a 1999 Grand Prix should you replace the engine or change the oil pump?
replace the engine the oil passages inside the block are clogged if you replace the pump the oil will still not get to the top end and you probably wore those parts metal to metal and did damage
What does not get dry in sunlight?
Metal do not dry in sunlight
What does not dry in sunlight?
Metal do not dry in sunlight
How do you read oil dipstick in a 1997 pontiac sunfire?
The oil dipstick is built into the oil filler cap. Unscrew the cap, pull the dipstick out, wipe it dry and reinsert it. Remove it again to read the oil level.
How do you remove linseed oil from car?
Pour 5W30 motor oil on it, and then cover it in sawdust, leave it overnight, then blowdry it. Finally, vacuum it up and dry with a papertowel. Voila!
