answersLogoWhite

0


Best Answer

ok

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove engine cover on subaru legacy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the cost to replace valve cover gaskets on 2001 Subaru legacy?

The cost to replace valve cover gaskets on a 2001 Subaru Legacy is about $600. If the work is done at home the cost is only $100 to $200.


Where is the fuel pump in a 2006 Subaru Legacy?

The fuel pump is in the gas tank.If you remove the floor carpet in the truck you will see a cover that can be removed to get to the fuel pump


Where is the starter on a 1991 Subaru legacy?

Top, front, center, under the plastic cover.


How do you replace valve cover gaskets on a 1992 subaru legacy?

Do you still need some assistance?


How do you replace the headlight bulb on a 2005 Subaru Legacy?

You remove the plastic cover with two "quarter revolve screws" Then you loosen the battery (or washer fluid container depending on which side it is) and loosen the plastic cap- remove the spring and remove the bulb. Assembly in reversal order /K


Where is the Subaru legacy 2003 fuse box diagram?

In my '03 wagon, the diagram is underneath the fusebox cover next to the battery


How do you get to the door speakers on a 1991 Subaru Legacy sedan?

Unfortunately, you have to remove the door panel cover. There are three or four screws and several pop-clips, but it is actually pretty simple. To remove the door panel, you have to disconnect the power connector and the speaker (just clips). Hope that helps


How do you replace 2006 subaru legacy fog light bulb?

Turn wheel in for easier access. Remove the two clips that hold the lower mud guard to the bottom of the bumper cover & move mud guard for access. Remove connector. Remove rear fog light cover by rotating counterclockwise. Remove spring clip & replace bulb. Re-install cover & connector. Verify operation. Re-install lower mud guard.


Briggs stratton engine How do you change a condenser on a 4hp?

you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,


How do you remove the engine cover on citroen xzara Picasso to get to the spark plugs?

were is engine cover wot does it do


How do you remove headlight lens cover on 97 subaru legacy for cleaning?

The headlights are sealed units, unfortunately they do cloud over a bit with age. Try a cut and polish on the outside of the lens to clean them up a bit, but you would have to go to a plastic welder or similar to get them to remove the housing, and even then, cleaning them may not remove the cloudy effect.


How remove engine cover for tfsi?

TFSI?