For 1978 and 1979 models at least you can remove the seats
simply by removing four bolts underneath the seats, one at each
corner.
If you have heated seats you will have to worry about wiring, I
have no experience with that or with later models.
Through the trunk under the carpet nearest back seat.
To remove the back seat from a 1991 Volvo 240 sedan, start by locating the rear seat bottom release levers, usually found at the front edge of the seat. Pull these levers to detach the seat bottom from the clips. Once the bottom is removed, you can access the rear seat back; it is typically secured with bolts or clips at the bottom. Unscrew or unclip these fasteners, then pull the seat back upward to remove it from the vehicle.
To replace the driver's seat in a 1990 Volvo 240 DL, first, remove the seat by disconnecting the battery and unbolting the seat from the floor using a socket wrench. Carefully pull the seat forward to access the wiring for the seat heaters or any electronic connections, and disconnect them. Next, position the new seat in place, reconnect any wiring, and secure it by bolting it down to the floor. Finally, reconnect the battery and ensure everything is functioning properly.
To replace the bulb in the heated seat switch of a Volvo 240 estate, first, carefully remove the switch from the dashboard by gently prying it out. Once removed, disassemble the switch housing to access the bulb, which is typically a small, replaceable type. Remove the old bulb and insert the new one, ensuring it fits securely. Finally, reassemble the switch and reinstall it into the dashboard.
Pull on them. They are held on with spring clips.
Remove the fuse from the fuse box. Or remove the relay.
under the driver seat, in the undercarriage, And one on the Sump in the tank.
1993 Volvo 240 WAGON 5spd manual transmission. there are two screws on iether side of the console. then its just a matter of disconnecting wires.
VERY CAREFULLY.
Begin by removing the positive cable from your 1990 Volvo 240 battery. Remove the cables from the front of the starter motor. Remove the starter motor retaining bolts. Reverse the process to install your new starter motor.
To fold down the rear back seat in an '87 Volvo 240 DL, first locate the release lever or strap at the top of the seat back. Pull the lever or strap to unlock the seat, then push the seat back forward to fold it down. Make sure to clear any items from the seat before folding it down to avoid damage. If needed, refer to your owner’s manual for specific instructions or diagrams.
2 Bolts on the back. Remove them and remove the Brake line, and Install new doing the inverse