Pull on them. They are held on with spring clips.
RWD
Remove the tire and wheel from your 2004 Mercedes 240. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
Remove the fuse from the fuse box. Or remove the relay.
1993 Volvo 240 WAGON 5spd manual transmission. there are two screws on iether side of the console. then its just a matter of disconnecting wires.
VERY CAREFULLY.
No. While the bolt circle is the same, the offset on the 240 wheel is incorrect, and the rim diameter is likely too small. You might be able to get it bolted on, but it may strike the brake caliper on the inside of the wheel, and the tire will likely rub on the fender.
Begin by removing the positive cable from your 1990 Volvo 240 battery. Remove the cables from the front of the starter motor. Remove the starter motor retaining bolts. Reverse the process to install your new starter motor.
2 Bolts on the back. Remove them and remove the Brake line, and Install new doing the inverse
long answer: yes
The ignition switch on a 1991 Volvo 240 is located on the steering column, just behind the steering wheel. To access it, you may need to remove the plastic cover surrounding the column. The switch itself is typically mounted directly to the ignition lock cylinder. Make sure to disconnect the battery before attempting any repairs or replacements.
It's in the trunk. Just remove the carpet and then you see the coverplate.
The fuel pump on a 1983 Volvo 240 DL is located under the car, near the rear axle, on the driver's side. It is typically mounted on the frame or near the fuel tank. To access it, you may need to lift the vehicle and remove any protective covers or shields. Always take necessary safety precautions when working under a car.