0
The ignition switch on a 1991 Volvo 240 is located on the steering column, just behind the steering wheel. To access it, you may need to remove the plastic cover surrounding the column. The switch itself is typically mounted directly to the ignition lock cylinder. Make sure to disconnect the battery before attempting any repairs or replacements.
What else can I help you with?
How do you replace an ignition switch in a 1991 Volvo SE Turbo Wagon?
replace ign sw on 1991 volvo 240
How do you reset engine Light on 1991 Volvo 240 DL?
how do you reset engine light on 1991 volvo 240
Where is the brake light relay located in a 1991 Volvo 240?
The 1991 Volvo brake light relay switch is located beneath the drivers side dashboard. The brake light relay switch will be above the brake pedal.
Would a 1987 Volvo 240 hatch fit a 1991 Volvo 240?
long answer: yes
What color wires go to what number on the ignition of a 1991 Volvo 240 dl?
In a 1991 Volvo 240 DL, the ignition switch typically has the following wire connections: the red wire goes to terminal 30 (battery power), the black wire connects to terminal 15 (ignition), the yellow wire is for terminal 50 (starter), and the brown wire is for terminal 31 (ground). It's essential to consult a wiring diagram for your specific model to ensure accuracy and safety during any electrical work.
Why does the Starter motor continue to operate when ignition switch is turned off on a Volvo 240 GL 1983?
wires on the starter are criss crossed
What type of brake fluid is in a 1991 Volvo 240?
DoT 4
1991 Volvo 240 sedan wont start with buzzing noise from dashboard Wont even turn over. When turning key it kind of clicks and buzzes a few seconds then nothing at all Lights are still on help?
ignition switch is bad. ignition is where the key goes. also try checking your starter. Gen-R
How do you change a 1993 Volvo 240 power window switch?
met poep
What is the wiring order for a 1990 Volvo 240 electric ignition?
For a 1990 Volvo 240 with an electric ignition, the typical wiring order for the ignition coil is as follows: the positive terminal (B+) connects to the ignition switch, while the negative terminal (B-) connects to the distributor. The distributor should be wired to the spark plugs in the firing order of 1-3-4-2. Make sure to consult the vehicle's service manual for specific details and diagrams, as variations may exist.
What is the number on a 1984 Volvo 240 ignition control unit?
Bosch 0 227 100 018
Where is the brake light switch located on a 1992 Volvo 240?
Above your left Knee when you are driving
