No diagrams here but there are several websites that show videos of the procedure on this and similar bikes. Here is how you remove the wheels.Front wheel: Jack the bike up in front or suspend it from a beam so that the front wheel is above ground. Use a 17 mm hex bit. Pinch bolts are 6 mm. Use a wooden dowel and tap the axle to remove it. Disconnect the speedometer cable. The wheel comes free. Be careful with washers and small parts. When reinserting the wheel, make sure the axle is aligned in exactly the right position. Use a bit of grease on the axle when you reinsert it. Fasten the end nut, it should have a cotter splice in place in the nut. Fasten the speedometer cable. Torque to proper specification. Rear wheel: Jack the bike up, remove the end nut on the rear axle, loosen retainer screw on swingarm, then remove the cotter pin from drum brake rod, finally remove the axle. Be careful with the axle spacer which comes loose at this time. Push the wheel to the front a bit, then remove the chain when it is slack. Slide the wheel from underneath the bike, free of the drive chain. Reinserting the wheel is the reverse process.
1999 Honda 750 Shadow reserve position is front.
Look under the seat. You will have to remove the back and front seats first. 8mm on the back and 12mm on the front. Remove 3 screws on the cover and there it is.
what wheel will fit Honda vt 600 vlx shadow
How do you remove the front sprocket from Honda trx 250r
it will explode
I have a 2000 Honda VT1100 Shadow Spirit. I am not sure the 750's or later models have the same setup, but it is a place to start. "REMOVAL" Remove the rear seat bolt. (It is located at the rear of the back seat at it's base; centered, and more or less straight down from the backrest. Remove the rear seat by pulling it up, back, and then up and forward. Remove the front seat bolts. (there are two, centered at the back base of the now exposed front seat). Remove the front seat by pulling up and back.
The Honda Shadow Spirit, recommends 29 psi in the front tire and 32-36 psi in the rear tire.
Collapse caliper(screw driver to pry caliper apart), remove brake pin plug, remove brake pin, remove pads, reverse for install
28 psi front, 36 rear.
2.0 bar front and back.
32 front, 36 rear.
remove the four bolts at the front and the rear