Thunderbirds never had a front axle
A 1994 Ram 1500 has a Dana44 front axle. A 2500/3500 has a Dana60 front axle.
Yes, if you remove the front axle first.Yes, if you remove the front axle first.
Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.
For Axle Nut its 30mm
Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.
a hammer
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman
The front axle nut on a 1994 Plymouth Acclaim is 32mm OD. A 32mm axle nut socket should be available at most parts stores.
You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.You will have to remove the front axle assembly to have enough clearance to remove the oil pan in vehicle.
To replace the front drive axle U-joint on a 1994 Dodge 2500 4x4, first, safely lift the vehicle and remove the front wheel to access the axle. Disconnect the axle from the differential and the wheel hub by removing the retaining bolts. Use a U-joint puller or a hammer and socket to remove the old U-joint from the axle yoke, then install the new U-joint by pressing it into place. Reassemble everything by reversing the disassembly steps, ensuring all bolts are properly torqued.
To change a CV axle in a 1994 Nissan Quest, first, safely lift the vehicle and remove the front wheel on the side of the axle being replaced. Next, detach the axle nut and the lower control arm to gain access to the axle. Remove the old CV axle by pulling it out of the transmission and install the new axle by reversing the process, ensuring all bolts are tightened to the manufacturer's specifications. Finally, reattach the wheel and lower the vehicle before testing for proper operation.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing