Want this question answered?
usually a couple bolts on the side near the front of seat then under the tunnel near the back a coupl more
120/90x18 front 140/90x16 rear
Its located on the front of the motor and removed from the bottom
Each front fork holds: 400cm3 or 14.1 oz or 13.5 US oz.
Remove the 10mm bolt from behing the rear seat. Then pull the rear seat it hooks to the front seat in the front. Remove the bracket there and pull the front.
It is located over the front head to get to it both sides of the fairings has to be removed and the battery box. Its a pain
It is a type of front suspension, like on the 1996 Yamaha V-Max 600's. Rides outside the hood and looks like a pogo stick on each side of the hood.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
the edge or the switchback
take bolts out at front left and right side then slide entire seat forward and lift off
Remove the screw on the panel below the front of the seat. Then open the seat and remove the two Phillips type screws near the seat hinge. Then remove the panel below the front of the seat and have a look. You can also take the storage container right out if you want to get in deeper.
Remove 4 screws from the front plastic remove plastic nut on the key switch push key switch through remove plastic nose. Buy new style nose. To install follow directions in reverse.