Want this question answered?
You need an axle stand, trolly jack, 13mm 15mm and 19mm socket, lump hammer, and a set of coil spring compressors. Firstly remove wheel, brake pipe and brake caliper(two bolts at the rear. Then remove track rod arm,(remove nut and tap with hammer and it will release. Then put the spring compressors on and tighten right up. Then undo the bolt at the bottom and to the rear of the suspension leg and now tap the hub downwards with a piece of wood and lump hammer. Once bottom release, lift bonnet and remove the 3 13mm bolts at the top and drop the suspension leg out.
you untie it:D
Its the suspension leg from the stub axle where your front wheel is to the car body is. It comprises a tube with a road spring on it and a damper inside. Offside means its the side usually away from the curb.
to remove the old one there are 3 fixing points one is at the ball joint undo but dont remove the bush bolts jack the leg up to keep the spring tolt remove from ball joint at this point be carefull not to pull the drive sharft out of the gearbox / remove the bush bolts and your done put the new one on the same way .
to remove the radiator from a mk2 mondeo start by removing the water pipes then the lower support bar that the radiator sits in is bolted to the chassis leg on both sides by for 13mm bolts once these are undone the radiator will drop off . if you have air con the air con rad will be bolted to the normal radiator so just undo the 2 bolts and slide it off but do not undo the air con pipes if you can help it as you will need to get it refilled
The shock absorbers have failed or are disconnected. Or the front springs are broken or too soft. Front suspension comes in a few varieties, the main two being McPherson strut where the coil spring is on the top of the suspension leg; and wishbone suspension where the the spring and shock are separate. An easy check is to firmly press down and release the wing (fender). It should come back up and make one slight 'overswing' before coming to rest.
remove the 4 nuts, one on each leg of the seat and unplug any wiring harnesses under the seat and pull out the seat.
Remove seat and re-drill mounting holes further back?
Front on bowling action is where the back leg is behind the popping crease and front leg is facing the batsman.
The 2013 Dodge Dart has 42.2 in. of front leg room.
Suspension trainers are an exercise best done in moderation. They have ones specifically made for leg exercises, such as resistance bands. The key to avoid over-tiring is to do only a few repetitions at a time.
The 2007 Kia Optima has 43.7 in. of front leg room.