1. Remove the speedometer dash by removing the two bolts on the front and the single bolt at the back closest to the seat.
2. Remove the driver's seat.
3. Remove the two bolts at the front of the gas tank that were under the speedo dash, and the two bolts at the back that were under the seat.
4. Disconnect the fuel line after lifting tank off of frame. Be careful not to let fuel leak onto air filter box underneath.
5. Set tank on a cushioned or padded surface, being careful to not damage the paint.
You need to remove the valve cover ((V8) motor) and remove the spark plug coils, then you can change the plugs.
Remove the old plugs, install new plugs.
Remove the spark plugs wire and remove the plugs wit a spaerk plug wrench or socket.
You can remove the drain plugs, on your VTX 1300, by loosening the plugs with a 5/8 five sided socket. Turn the plugs to the left to remove them.
Remove the fuel tank, Remove air box, Remove spark plug caps, Remove spark plugs ????
It is suggested that the oil be changed on the Suzuki Raider J when it is ready for a tune up. It is also recommended that all other fluids be checked and you should change the spark plugs.
Remove old spark plugs. Insert new spark plugs..... Simples
just remove the coil's that are on top of the plug, then change the plugs.
Remove the upper intake, then proceed as with the other plugs.
The only way to change the plugs is to remove the top cover first. Then remove the cover for each plug.
Disconnect the battery, remove the cover, remove the cables and boots, and remove the spark plugs. Put in the new spark plugs, replace the cables and boots, replace the cover and connect the battery.
4 spark plugs