# Raise the seat (as you would to add gas) # Remove the 2 springs that the seat rests on (use a socket with extension).
# Remove the gas line, use needle nose pliers to squeeze open the clamp, then pull the hose (this is under the body panel, access from the rear, on top of the tank)
# Have a helper lift up on the rear of the body panel, reach under the panel and lift the gas tank out.
# Install in reverse order. The body panel is quite flexible...I called a JOHN DEERe service shop and this is how they do it. 10 minute job.
If the tank is below the seat... # Raise the seat (as you would to add gas) # Remove the 2 springs that the seat rests on (use a socket with extension). # Remove the gas line, use needle nose pliers to squeeze open the clamp, then pull the hose (this is under the body panel, access from the rear, on top of the tank) # Have a helper lift up on the rear of the body panel, reach under the panel and lift the gas tank out. # Install in reverse order. The body panel is quite flexible...I called a John Deere service shop and this is how they do it. 10 minute job.
A good way to drain the gas would be to very carefully detach the gas line from the carb and let it drain into a bucket. One could also use a hose and pump to suck the gas out of the tank and into a bucket without removing the gas line if they do not know how to identify the gas line and do not have the manual to their mower.
how do you remove the gas tank on a john deere stx 38 riding lawn mower
why does my motor shut off on a exmark lazer riding motor
pull
How do you change a mower deck belt on a John Deere L130?Read more: How_do_you_change_a_mower_deck_belt_on_a_John_Deere_L130
on the mower deck
If the L130 is a John Deere then you can go onto their web site and find it there.
Under fan
To replace the front wheel on your L130 John Deere lawn mower you need to first take out the old one. Place the jack under the front wheel frame of the lawn mower, then place the new bushings over the axle hole in the wheel.
They are metric bolts 8mm x 1.25 pitch and are hard to find anywhere but your local JOHN DEERE dealer.
with a grease gun
Do not know what you ask for, but try the link below to Deere:
A John Deere belt diagram can be found in an owner manual. The manual should have all the diagrams, and other information for the tractor.
10w-30 2qts
Its on the engine next to the fuel filter
I cant seem to get the new pinion gear to go on the drive shaft of my John Deere LA105. Is there a trick to it?