try a washer on the variator located within the transmission. between the front pulley left and right assembly parts.
how do i find and remove a govener on scooter
all you have to do is take it off, how hard can it be.
I believe that there is no mechanical speed governor. It is controlled by the PCM which you would have to reprogram to increase the limit.
inside the exhaust pipe. remove pipe to find washer(aka governor) in head pipe.
disclaimer--this can make your scooter a "motorcycle" by law in some states open seat, remove four bolts, remove helmet compartment/seat assembly, bundle wires goes to a black/brown box, this is your ecu. pull back the plastic sleeve on this box, clip green wire. according to a dealer this gets you to about 42 mph.
The Yamaha Governor is attached to the top of the fuel pump. Remove the governor retaining screws. The governor will come off.
If you are having problems with the engine, take the scooter in for repairs. Since it is a late model, I would think it is still under warranty. If you are wanting to remove the governor to get higher rpm's and more speed, DON'T DO IT. The governor plays an important part in maintaining the engine at optimum performance by governing maximum speed. If you remove the governor, you will be risking serious damage to the engine due to uncontrolled overspeeding.
There is no governor to remove. Speed is controlled by the ECU.There is no governor to remove. Speed is controlled by the ECU.
18-25 That's if you don't remove the governor. Removing the governor will mean instead of only revving to 3600rpm it can now rev to 6000rpm with a corresponding increase in top speed. To remove the governor go to youtube and search for box stock race prep.
It is located in your vehicles computer very complicated. If removed wrong it can cause problems
The governor is located in the transmission it is a silver cylinder that goes inside the transmission unplug the unit and remove the two bolts that hold it in place."PRO TIP your speedometer will not work when the Governor is removed as the two work hand and hand...
Remove the Real Scooter Wheel and Brake (brake if not fitted to new deck)Loosen Scooter Handlebar Clamp and remove barsRemove headset cups and take out Scooter forksSimple you should be left with a deck. Transfer the new parts if compatible to the new Deck.