Want this question answered?
How to remove drivers' side light cover
lift the handbrake boot thing up from around your hand brake lever there is a 10mm nut tighten it up not too much other wise ur back wheels wont turn or will lock up you may need a 10mm long socket not a short-normal 1
Lock stuck or cable broken. You will need to get into the boot space throught the back seat and remove as much trim as needed until you can see the lock then open it from there manually.
boot
Disconnect the battery, remove the engine cover, remove the spark plug cables and boot covers, and remove the old spark plugs. Put in the new spark plugs, attach the boot covers, and cables, replace the engine cover, and connect the battery.
there are three on my vectra c 2002 1 is in the engine bay on the left and 1 in the passenger side of the dashboard and one in the boot
In the boot, remove cover /carpet on top right side
turn on engine.Have handbrake on.Undo catches above doors.Press roof button.Windows should go down and boot comes up.when beeping changes remove finger from button and undo roof lever.then press button again and roof should go into boot cavityy.when boot goes down each time remove finger off button and replace until boot closes.
apply handbrake, find the locking wheel nut, remove toolkit from boot, crank the wheel nuts on said wheel (do not remove), affix jack, pump the jack till the said wheel has airtime and remove the loosened wheel nuts. and as ramsey would say 'done'
i guess your talking about a top loader remove the boot then remove the cover and you will find a pin holding the shifter to the trans. take a punch or pliers to remove the pin takes about 3min.
Remove the retaining cover from the front of the CD changer. Remove the CD changer retaining screws. Remove the wiring harness from the back of the CD changer.
Take off your gas filler cover-four small screws-Remove gas cap and rubber boot-remove the three rubber gas lines-Then remove 10 cover bolts-pull unit out.