lollolol
The turn signal module is combined with the hazard light module. You need to remove the dash trim to get to it. It is right behind the hazard light switch.
The flasher is built into the hazard light switch. You have to remove dash and take it out from the rear of the dash panel.
Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.
The flasher unit is contained inside the hazard light swith on the dash. You need to remove the dash panel and pull the switch out from behind. The entire switch must be replaced which is about - at a Chevy dealer.
The flasher is built into the hazard light switch. You have to remove dash and take it out from the rear of the dash panel.
the signal flasher is the hazard light switch......remove the radio bezel and change the switch
the flasher unit is built into the hazard light switch on dash you have to remove the small cover around switch unit & remove switch remove plug from back & replace whole unit
remove trim plate around switch,take out screws holding switch in,remove wires then replace in reverse order!!
hazard switch dont lights on
the back?
The hazard switch is located on the button itself. In a 1999 Honda Civic find the hazard button, which is located on the dashboard.