Wiki User
∙ 16y agofor a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan? for a 1994 Grand Caravan (probably like the 1995) see: How do you replace the headlight assembly located on a 1994 Dodge Caravan?
Wiki User
∙ 16y agoOpen hood, remove headlamp bulb from headlamp assembly, remove (1) 10mm bolt from top of headlamp assembly, next remove (3) 10mm bolts from behind headlamp assembly, pull headlamp forward ( you may have to pry gently from the right side). Remove turn signal bulb-Done!
Loosen the screws of the lower grill and headlamp assembly so that it can be removed from the fenders. Remove the upper grill fasteners and remove the grill. Take off the headlight housing. Remove the headlamp motor and housing. Take out the headlight. Now the fender can be unbolted and removed.
For each headlamp, Remove the two 15mm Bolts that have a six pointed star in the middle of the head. The glass headlamp will then slide forward and you can reach behind and remove the lamp unit.
I just had to replace mine. There are 3 screws that hold the housing to the vehicle. Remove the 3 screws and slide the housing out. The bulb goes in the housing from the back. Turn the lock ring, remove the old bulb, disconnect the bulb, put the new bulb in in reverse order. The bulb bracket has notches in it. Align them carefully with the tabs in the headlamp housing.
* Unplug the electrical connectors and remove the halagen bulbs * Remove the front combination (park and turn signal) light housing and the screws along the top of the front bumper cover * Remove the headlight housing mounting bolts and remove the housing
You must remove the 3 bolts on the opper part of the headlight housing and then remove the entire housing. You can then reach the bulb connection
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
Open the hood to the engine compartment. Remove the headlamp wiring harness. Remove the headlamp assembly retaining bolts. The headlamp will come out.
Remove the air intake splash shield from the vehicle. Remove the 2 headlamp retaining bolts. Remove the lamp assembly from the front of the vehicle. Detach the headlamp connector. Remove the headlamp bulb retaining ring. Remove the headlamp bulb from the headlamp.
Check your owner's manual first in case yours is different for some reason. Open the hood. Remove the bolt holding in the yellow light (side marker) housing. I did not have to completely remove the side marker housing, but it had to loose enough to allow the headlamp housing to come out. Remove the two bolts securing the headlamp housing to the chassis. Here's the part that isn't obvious: Behind the headlamp housing there is a squarish opening in the chassis. Insert a flat blade screwdriver through the opening. Make sure the screwdriver fits through the opening in the headlamp bracket lower arm. It's kind of hard to see, but if you wiggle the housing, you'll see where the lower arm connects to a bracket on the chassis. Push the locking tab toward the rear of the vehicle with the screwdriver to lift the headlamp bracket lower arm. Lift up the housing. You will have to wiggle it a little to get the housing out from behind the side marker housing. Once it's out you have plenty of room to get to the wiring assembly and bulb. Detach the wiring assembly, rotate the bulb counter clockwise and it should come right out. Reverse the process with the new bulb.
There are 2 long clips behind the headlight housing, remove them and the housing will lift out. Then just unscrew the bulb and replace with a new bulb.
Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector