Ford F-350

How do you remove heater core hoses 1999 ford F-350?

345

Top Answer
User Avatar
Wiki User
Answered
2010-04-03 21:00:29
2010-04-03 21:00:29
  1. Drain the radiator..
  2. Disconnect the heater water hoses from the heater core.
  3. Disengage the stops and lower the glove compartment door.
  4. Remove the electronic blend door actuator and bracket assembly.
  5. Remove the screws.
  6. Remove the heater core cover.
  7. Remove the heater core.
  8. Follow the removal procedure in reverse order......
001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


how do I change the heater blower on a f350 2002


no heat can be caused by,blocked heater core insufficient coolant in engine blocked heater hoses from engine to heater core bad heater thermostat bad thermostat in engine bad heater control switch


The blend air door is probably broken.


No, the 2003 Ford F350 rims will not fit on a 1999 Ford F350.


hi my ford f350 heater blower wont run.was trunning then stopped. Where is it located


Yes, the rims off a 2002 Ford F350 will indeed fir on a 1999 Ford F350.


Driver side of the engine low back.


The plug should be hidden in the bumper in the vents.


If there is no cord hanging you have to buy one.not all trucks came with thr cord.the heater is in the block.check for the cord by the grille....vinny


there is no repair for a belt tensioner. just buy a new tensioner. remove old belt, remove old tensioner, it is held on with one bolt. install new tensioner. install new belt


remove column dust covers, along with ignition switch. then remove retaining


remove wheel remove brake caliper remove locking hubs special tool required to remove axle nut


I need a diagram of ford F350 drum brakes on 1996 model 460 engine 4 wheel drive


Loosen Nadar pin and move, BUT DO NOT REMOVE


the best way is to cut it out and use a new seal


32.75 quarts ( includes the heater and 5 quarts in the coolant reservoir )




remove the inner wheel well and it will be there


use the removal tools in the holes on the sides of faceplate


to remove a 6.8 v10 from a f350 2003 do you have to remove front end


whats the maximum cargo weight of a 2001 f350


on top of the motor in the front there is a cover ,,its under that you can use a 1/2 inch rachet to remove the lid and ther you will see the filter. there is a lever on the side to drain the bowl


Remove the filler neck hose from the tank and insert a syphon hose.


check for a cable comming out of the transmission even if its electronic



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.