0
Open the hood and look on both sides near the hinges. There is a spring on each side. Grab the motor end of the spring and pull the end off of the bracket. Once you have both springs removed, lower the hood about 3/4 of the way and pull the bottom front of the hood forward off the hinges.
Wiki User
∙ 15y ago
Wiki User
∙ 14y agoRemove 2 clevis pins from front of mower deck and 2 more from the rear. Remove drive belt from lower pulley on engine side, then deck should be able to be removed by sliding out from left or right of mower frame. Removal is made easier of mower deck if height adjustment is in its lowest position after mower deck drive belt is removed.
Wiki User
∙ 10y agoOpen hood. Remove two bolts (one on either side) near hinge point of hood. Close hood. Remove two bolts holding hood assembly to front of frame from underneath. Remove hood assembly.
Tom Griffis
Thank you for your help
Add your answer:
Earn +20 pts
How do you change a mower belt on a stx38 john deere lawnmower?
Outdoor Power Equipment Website
Where can i find a John deere stx38 belt diagram?
Go to http://outdoorpowerinfo.com/repairs/deere_stx38_gear_drive_belt.asp for pictures and descriptions of installation of drive belt and deck belt for John Deere STX38 Tractor with black mower deck.
How do you remove a flywheel on a John Deere stx38?
stx 38 fly wheel
How can you tell what year a john deere stx38 riding mower was made id tag says m00stx8597946?
moostxc255457
How do you remove the deck on a John Deere stx38 lawn tractor?
Is your STX 38 a black deck or yellow mower deck color?? Bob Lituri lituri54@aol.com
Where is the serial number located on a John Deere model STX38?
There should be a tag on the very rear of the mower, behind and below where the drivers seat is that will have that information. what years were john deere 920 built
Stx38 John Deere will not move?
eat S_H_I_T
What fram oil filter goes on a john deere stx38?
Fram PH7575 is what I use on my STX38.
How do you check transmission on john deere stx38 hydro drive?
how do i check the hydro transmisson fluid on a stx38
Where do you connect Brake Spring on John Deere STX38 Riding Mower?
one end on the undercarriage (1/8 holes) the other end on the shaft that goes to pedal
How do you engage the mower for a John Deere stx38?
The STX-38 should have an electric clutch for the mower deck. The switch to engage it is on the right rear fender. It is a toggle switch. You will have to pull up on the switch and forward to engage the blades.
What is the torque for the head on stx38 John Deere lawnmower?
30 lbs
