0
As you look at the switch there should be a ring with three notches or groves, this is the nut that holds the switch in. If you are careful, you can use a regular screwdriver in one of the groves and tap it with a hammer to break the nut loose. You should then be able to remove the nut by hand and push the switch through the dash. Reach under the dash and pull the switch down so you can see the wires on the back. I am not 100% sure if it is a single plug or if there are several wires (although I believe it will be several separate wires). If you are putting in a new switch, make sure you have the new, and correct switch for the next step, remove the wires one at a time and reinstall them on the new switch. Once you are done with this, just put the switch back in and you're done.
Hayden
What else can I help you with?
How do remove the ignition switch on 1978 Chevy truck?
High-powered explosives.
How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Wiring diagram for ignition switch for 1974 Chevy truck?
Ignition wiring diagram
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
How do you remove and repair replace an ignition switch in 1996 1500 series Chevy truck that sticks in the off position?
call a lock smith .
How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you change the ignition switch on an 87 Chevy C-10 pickup truck?
you have to remove the steering wheel, after that you need a tool to releave the tenison on the plate that looks like a sun there is a clip to remove. after that if you look where the switch is you will see a screw, if you remove it the switch will come out.
Where would the ignition switch be on a 1978 Chevy Cheyenne truck.?
On a 1978 Chevy Cheyenne truck, the ignition switch is typically located on the steering column, just behind the steering wheel. You can access it by removing the plastic cover around the column. The key slot will be positioned at the front of the ignition switch, allowing you to insert the key to start the vehicle.
How do you remove the ignition switch on a 1968 Chevy truck?
turn key to acc then stick a paper clip in the little hole in tumbler then turn counter clock wise there you go
How do you remove the ignition lock cylinder on a 1964 Chevy puck up truck?
Turn it, then pull up and out.
Will a bad ignition switch shut down the electrical system on a 1994 Chevy truck?
A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.
How do you remove the ignition key switch on a 1998 Chevrolet truck?
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
