High-powered explosives.
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Ignition wiring diagram
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
call a lock smith .
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
you have to remove the steering wheel, after that you need a tool to releave the tenison on the plate that looks like a sun there is a clip to remove. after that if you look where the switch is you will see a screw, if you remove it the switch will come out.
On a 1978 Chevy Cheyenne truck, the ignition switch is typically located on the steering column, just behind the steering wheel. You can access it by removing the plastic cover around the column. The key slot will be positioned at the front of the ignition switch, allowing you to insert the key to start the vehicle.
turn key to acc then stick a paper clip in the little hole in tumbler then turn counter clock wise there you go
Turn it, then pull up and out.
A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
To install an ignition switch in a GMC truck, first disconnect the battery to ensure safety. Remove the steering column cover to access the ignition switch, typically located near the ignition lock cylinder. Unscrew the old switch, disconnect the wiring harness, and then attach the new ignition switch, ensuring all connections are secure. Finally, reassemble the steering column cover and reconnect the battery to test the switch.