0
Turn the key to the "acc" position.
After removing panel underneath, find a little hole on the bottom of the cylinder.
using a small screw, or pin (whatever fits) push up into the hole, and pull out the cylinder.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Toyota Corolla hot ignition switch?
The ignition of my 2002 Corolla also gets hot? Any others?
How to bypass ac low pressure switch on Toyota Corolla?
You can bypass the AC low pressure switch, on your Toyota Corolla, by removing the switch. You can remove the wiring to the switch and leave the switch and place.
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
Where is the starter relay switch on a 1996 Toyota Corolla?
where is the starter relay switch on a 1996 Toyota corolla
How do you remove the ignition switch on a 1990 Toyota corolla?
other then taking out the dash board turn your ignition key to acc and it should pop right off. plus if you go to autozone.com and look up ur ignition it will give you directions on how to take it out and replace it
Where is the ac relay switch on a 2004 Toyota Corolla?
this relay switch is located behind the glovebox. You have to remove the entire glovebox to get to it
Why will a Toyota corolla with a brand new battery not turn over?
Bad Starter. Bad Starter Relay. Bad Ignition Switch. Bad Ignition Module. Improper Ground.
How do turn off hazard lights in 2009 Toyota Corolla?
where is hazard light switch on toyota corolla
How to remove ignition switch 1984 Chevy Caprice?
How to remove ignition switch
Does the Toyota corolla have a fuel cut off switch?
No it does not
Where is the oil pressure switch located on a 1990 Toyota corolla?
I located the oil pressure switch but it hard to get to with out having to remove other parts. Any easier way?
How do you replace ignition switch on a 2000 silverado?
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
