Want this question answered?
Insert the key into the ignition Turn the key to the accessory position Use a pin or paper clip to slightly push into the little pinhole located next to the key and turn the whole cylinder counter-clockwise while pulling it out. This operation removes the cylinder. -push the ignition switch from the rear and turn the retaining nut (the ring that says "acc-on-start") counter-clockwise and remove the retaining nut. This should cause the whole assembly to come apart. Remove the nut from the back of the switch and remove the wire. Remove the connector from the back of the switch. Install by repeating in reverse order..... That is all!!
Mercedes Coghen was born in 1962.
The maximum speed of Mercedes Benz190-D diesel 4cyl 60HP 1962 was 84 miles per hour.
Very few trucks at that time had automatic transmission. So you can start a manual transmission by pushing it off. Turn on the ignition switch. Place the gear into 2nd gear. Depress the clutch. Push the truck to about 5 to 10 mph and release the clutch and the engine will start.
In the early 1960's (1962-63)
remove instrement cluster from a 1962 tbird
it's on the top side of the headlight switch and you generally have to take the switch out to get to the fuses.
Doesn't have hazard lights.
Behind the light switch
( Disconnect the battery first) Feel behind the dash for the back of the switch, on the apposite that the wiring is you will feel a small spring-loaded button. Pull the switch out to the headlight position, push the button in at the back and the knob will be released, pull the knob out the rest of the way and undo nut at the front the switch is now yours. old sparky from way back hope this helps
HI there. Turn key to ACC position. You will see a little hole on the key barrell. Just get a paper clip or something and push in and than pull out the lock key and all. hope it helps
Reverse lamp switch for the 1962 and 1963 Pontiac Tempest