If it's a Standard transmission [Stick shift] you need to put it on Neutral apply Emergency Brake.. there's a Tab on your shifter under the shifter knob and you need to lift it with your Index finger and middle finger to deactivate it.
Removing a ignition lock cylinder from a 2002 ford windstar with no key
if you go to www.impalahq.com and find where you take the dash off this will get you in the right direction. i know you have to remove the dash to remove the key switch.
On the 2002 Thunderbird, a person can remove the hard top with a new mounting key. An automotive parts store or a dealer will be able to order the mounting key for that vehicle, if they do not have one in stock.
Try to put your car on the parking breakes.
That's a 7mm Allen key.
The Simpsons - 1989 The Old Man and the Key 13-13 was released on: USA: 10 March 2002 UK: 28 July 2002 Hungary: 5 October 2002 Germany: 3 May 2003
It should be in a ziplock type of bag with your jack in the side compartment in the back of the car.
To reprogram the key for a 2002 Land Rover Discovery, you'll need to have both the original key and a new key. Insert the original key into the ignition and turn it to the "ON" position without starting the engine. Remove the key and then insert the new key within ten seconds, turning it to the "ON" position as well. The vehicle should respond with a locking and unlocking sound, indicating that the new key has been programmed successfully.
Try using old key turn from "Off to on" not starting car 7 times--remove and insert new key use same procedure--then try to start w/new key. If you have 2 "old" keys do the same thing with 2nd old key before using new
You need a 7mm Allen key.
You remove four screws with a small L key and then carefully remove the top plastic from the speaker ......then remove the speaker from the lower plastic.....Its a bit tuff but it can be done and then replace speaker.....you also need to remove the receiving part from old speaker and use it to connect you new one. or you can cut off the plug and connect speaker direct and tape it
you need to remove the steering wheel to reach the bolt that hold the old ignition switch need some tools that can be found at "auto zone" shop to be able to pull out the steering wheel and remove some parts to see that bolt.or you can call a car locksmith.