Auto Parts and Repairs
Starters and Ignition Systems

How do you remove key stuck in ignition on peugeot 406 hdi?

Top Answer
User Avatar
Wiki User
Answered 2014-09-17 23:25:26

To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.

User Avatar

Your Answer


Still have questions?

Related Questions

How do you change the ignition coils on a Peugeot 406?

How do you change the ignition coil on a peugeot 406 coupe?

How would you remove a starter motor on a Peugeot 406 LX DT?

how do youremove a starter moto on a peugeot 406 please

How do you remove a fuel pump peugeot 406 2.0 lx petrol?


How do you remove a driveshaft off of a peugeot 406?

This is a complex procedure, get a manual for this vehicle.

Where the hom on the Peugeot 406 2.0hdi?

WHERE THE HOM ON THE peugeot 406 2.0hdi out sade

Peugeot 406 reversing lights staying on?

probably the switch stuck on. pull out fuse in mean time

How get 406 peugeot started as immoblizer will not work?

Had the same problem on my 406 coupe 3.0ltr-Try turning on ignition and pressing the keyfob-worked for me, good luck!

What is the wrench symbol means in 2000 peugeot 406?

The wrench symbol is the service indicator. On the 406 the wrench symbol is displayed with milage to service when ignition is switched on.

Diagram of front suspension on Peugeot 406?

were will i get information for 1996 peugeot 406 petrol

How do you replace a heater matrix on a Peugeot 406?

not an expensive job to do. part cost about £10 but apparently it is an awkard job as a part of the dash on passengers side needs removing to get in at it. how do you remove a heater motor from a peugeot 406 do you have to remove the full dashboard or just the glove compartment

When was the first Peugeot 406 car made?

The first Peugeot 406 was made in 1995. It was made by a the French Automaker Peugot to be a family vehicle. The 406 was last made in 2003 and then was replaced with the Peugeot 407 model.

After changing the fuel fitter on a peugeot 406 hdi how do you bleed it?

turn on ignition wait 15 second and start hdis are self bleeding

How do you change the fan belt on your peugeot 406?

how do you change a fan belt on a 406

Engine oil Peugeot 406 diesel?

how to change oil filter in my peugeot 406 just simple directions and do's and don'ts? Thank you!

Peugeot 406 Break How can you remove the panel for replacing the rear speakers?

Undo the 12mm nut from under the speaker in the boot.

Where are the core plugs on a Peugeot 406?

on the engine

When do you change the timing belt on a Peugeot 406 2.0 hdi?

hi there can please show me the timing diagram to my 2003 peugeot 406 2ltr hdi

Jaki akumulator do peugeota 406 2.0 hdi?

peugeot 406 2.0 HDi

How do you reset service indicator peugeot 406?

Turn ignition off press and hold mileometer reset button. Turn ignition on, Service timer starts countdown to zero, Turn ignition off, release reset button, Turn ignition back on. It should now have reset the service miles. This worked on a 306 try it, it might work on a 406. Hope this is of some help.

Length of a Peugeot 406?

The 406 saloon is 4598mm long, the estate is 4738mm, the coupe is 4615mm.

Is the gearbox on a PEUGEOT 806 the same as a 405 or 406?


Where is the oil filter in a Peugeot 406?

under the bonnet

How do you change a car cigarette lighter in a Peugeot 406?


Fan belt fitting diagram 406 hdi?

Fanbelt fitting diagram Peugeot 406 hdi

Where are the timing marks on a peugeot 406 hdi 2.0?

The timing marks on a Peugeot 406 HDI 2.0 is on the front of the crank pulley. You can get a diagram by purchasing a Haynes Repair Manual.