NO you cannot heat as any flame can cause a severe explosion and the very least crack the CI fitting
The threads have to be cut out gently and possibly re tapped
With a extractor
by using "BANG"
You have to NAME the glue before we can answer that.
Bathe in a bathtub full of mansauce.
form_title= Bathtub Liners form_header= Keep your bathtub protected with a new liner. What color liner do you prefer?*= _ [50] What type of tub do you have?*= _ [50] Do you need to remove an old liner?*= () Yes () No
Depends. What it is broke off in. Sometimes you can use a hacksaw blade and cut through the male part just through the threads and then pry out the piece. I have sometimes had to make three cuts and take the pipe out in sections. If it is in another pipe and you can heat the end, this will loosen the pipe and an E Z out or extractor can be used to back out the piece. If it is a small pipe that is too small for a hacksaw blade, if you are very careful and lucky, you can drill out most of the pipe to the threads in the female part and then peal out the thread or rethread the female side which will clean out the threads.
with white spirit. (its a fact)
An inside pipe wrench also called a pipe extractor. It drives into the broken off pipe and is then turned with a crescent wrench.Normally a extractor or inside pipe wrench does not work removing a pipe . What works best is the use of a hack saw blade and a chisel to cave in the threads after the threads are cut.. BECAREFUL not to cut into the fitting threads
form_title= Bathtub Drain form_header= Fix your bathtub with help from experts. When did your drain stop working?*= _ [50] Does that bathtub drain empty water too slowly?*= () Yes () No Do you own or rent your home?*= () Own () Rent
There is a tool called easy out.
you grab it and then you summon the gods of bathroom strength, hopefully they give it to you, and then you pull
The top seems to have a filler in it?????