You've been driving your car up the wall ! -Cool. - Kilz might do it, but that's not normally what it's supposed to cover.
Shout removes stains from jam, grass stains, coffee stains, ink stains, blood stains, motor oil stains, etc.
Open the bonnet, remove the scuttle cover, wiper motor, and finally blower motor.
remove glove box look at motor area unplug wires to blower motor, remove cover over motor, 5 screws to remove then take out motor and fan assm.
It is located on the wiper motor. It can be changed with wiper motor in place. Unplug the wire harness at the wiper motor, remove the three small screws holding a black plastic cover, remove the cover and gently remove the pulse board.
# Remove the windshield wiper arms # Remove the cowl cover # Disconnect the electrical connector from the wiper motor # Detach the wiper motor/linkage assembly from the cowl # Remove the wiper motor retaining bolts and remove the motor
* Remove the windshield wiper arms * Remove the cowl cover * Disconnect the electrical connectorr from the wiper motor * Detach the wiper motor/linkage assembly from the cowl * Remove the wiper motor retaining bolts and remove the motor
at the base of the wiper the cover can be lifted so you can access the nut and remove the wiper. Once that is off you can remove the base cover to get to the motor.
It is attached to the wiper motor. It can be easily changed without removing the wiper motor. Unplug the wire harness to the wiper motor, remove the three small screws holding the cover in place, remove the cover, remove the pulse board.
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.
Mounted on the firewall directly behind the brake master cylinder reservoir. UNDER WINDSHIELD WIPER COWL COVER remove the wiper arms remove the windshield wiper cowl cover disconnect the eletrical connector from the wiper motor and remove the motor remove the wiper motor retsining bolts pry the linkage arm off the wiper motor pin with large screwdriver
1 Remove wiper arms and cowl cover its held on by plastic clips. 2 Remove remove spring clip on motor arm. 3 Remove the three nuts holding motor. And drop motor down in engine compartment Unplug the 2 cable plugs. Remove motor.