Put the armrest in the upright position. Push in hard on the armrest and move past the 12 O'clock position to about a 10 O'clock position. There is a sweet spot that will allow it to be pulled out. This works on 93 and 95 model years. .
To remove the armrest in a 2002 Dodge Caravan, locate the bolts holding it in place. Remove the bolts and carefully life the armrest off the seat.
Unzip the armrest cover and pull forward. You will the see the bolt that holds the armrest onto the seat.
push in armrest at pivot point turn armrest to rear over the top and pull off
I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.
Using a flat head screw driver, pop off the two plugs that are oval shaped on both sides of the armrest (the plugs are located below the armrest to the side of the seat in the console). Inside you will see two hex screws on each side. Remove the screws and the armrest and bracket list up. I haven't figured out how to remove the bracket from the armrest yet.
remove the arm rest cover , you can see the bolt
Remove the big round plastic plug and use a 15mm socket to remove the bolt....That's it
An armrest is a part of a seat or chair designed to support the arm.
Remove the seat. Remove the battery. Replace the battery. Replace the seat.
You will have to pull up the seat fabric on the backrest enough that it exposes the area where the armrest is mounted. Inside you will see the pole from the armrest coming into the seat, held in place with a sort of horseshoe shaped clip. The clip also has a rubber band holding the two open ends tight together. Using needle-nose pliers, remove the rubber band. Then take screwdriver and push the clip backwards out of it's groove. The armrest will then come right out. For re-installation: before placing the armrest back on, attach the clip and the rubber band and re-seat the fabric properly. Once the seat is ready, simply shove the armrest through the hole and you will hear a "click" meaning the clip has grabbed the armrest.
hello is anybody there ? What year and model might help. Simple. Lower the armrest, then push IN HARD. The armrest will push in slightly towards the seat. When this happens, push DOWN on the armrest, twisting it until just about straight downwards. You'll feel the armrest loosen up. Jiggle it slightly while PULLING OUT on it-- it should then pull out of the seatback. After it's out, you'll see it operates by a pin on the armrest shaft that fits into a keyhole on the seat.
You must remove the seat from the truck. It is attached to the floor of the cab with 4 bolts, I think. When you get the seat out, turn it over and you will see how the arm rest is attached.