I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.
Yes.
how to remove the vent from dashboard of 1996 ford contour
Usually located behind the driver's door panel. Remove inside door panel for access
Using a flat head screw driver, pop off the two plugs that are oval shaped on both sides of the armrest (the plugs are located below the armrest to the side of the seat in the console). Inside you will see two hex screws on each side. Remove the screws and the armrest and bracket list up. I haven't figured out how to remove the bracket from the armrest yet.
dynamite
You don't.
The 1999 Ford Contour OBD 2 port is under driver side dash next to kick panel
The 1999 Ford Contour OBD 2 port is under driver side dash next to kick panel
Use a 3/8" nutdriver, or 1/4" drive ratchet with short extension and 3/8" socket. There are 3 each hex head fasteners spaced across the bottom of the armrest. Takes about 2 minute to remove them and the armrest.
get a mechanic? (are you retarted?)
take off the screws
Under the center console. Remove 2 screws under cup holders, 1 screw under 1/2 inch plug behind armrest, remove cover behind and underneath armrest (pry off) to get to 2 screws holding armrest on and remove it.