Put the armrest in the upright position. Push in hard on the armrest and move past the 12 O'clock position to about a 10 O'clock position. There is a sweet spot that will allow it to be pulled out. This works on 93 and 95 model years. .
To remove the armrest in a 2002 Dodge Caravan, locate the bolts holding it in place. Remove the bolts and carefully life the armrest off the seat.
Unzip the armrest cover and pull forward. You will the see the bolt that holds the armrest onto the seat.
push in armrest at pivot point turn armrest to rear over the top and pull off
I have a 2000 Contour and there was a 19mm stud between the armrest and seat. It is hard to see and get the wrench on.
To remove the armrest from a Renault Trafic van, start by locating the screws or bolts that secure it to the seat frame. Typically, these are found underneath the armrest or on the sides. Use a suitable screwdriver or socket wrench to remove the fasteners, then gently lift the armrest off the seat. If there are any clips or covers, ensure these are also detached before fully removing the armrest.
To remove the armrest on a Freightliner truck, first, locate the screws or bolts securing the armrest to the seat frame or door panel. Use the appropriate tools, such as a screwdriver or socket wrench, to unscrew or unbolt these fasteners. Once all fasteners are removed, gently pull the armrest away from the seat or door. Be cautious of any wiring if the armrest is equipped with controls.
To remove the fold-down armrest in a 1999 Ford Ranger, first, locate the screws or bolts securing it to the seat. Use a screwdriver or socket wrench to remove these fasteners. Once the fasteners are removed, gently pull the armrest away from the seat, ensuring any clips or tabs are disengaged. If the armrest is attached to a seat cover, you may need to carefully detach the cover as well.
Using a flat head screw driver, pop off the two plugs that are oval shaped on both sides of the armrest (the plugs are located below the armrest to the side of the seat in the console). Inside you will see two hex screws on each side. Remove the screws and the armrest and bracket list up. I haven't figured out how to remove the bracket from the armrest yet.
remove the arm rest cover , you can see the bolt
Remove the big round plastic plug and use a 15mm socket to remove the bolt....That's it
An armrest is a part of a seat or chair designed to support the arm.
You will have to pull up the seat fabric on the backrest enough that it exposes the area where the armrest is mounted. Inside you will see the pole from the armrest coming into the seat, held in place with a sort of horseshoe shaped clip. The clip also has a rubber band holding the two open ends tight together. Using needle-nose pliers, remove the rubber band. Then take screwdriver and push the clip backwards out of it's groove. The armrest will then come right out. For re-installation: before placing the armrest back on, attach the clip and the rubber band and re-seat the fabric properly. Once the seat is ready, simply shove the armrest through the hole and you will hear a "click" meaning the clip has grabbed the armrest.