wire brush
how do you remove the battery? We have all the terminals off but still cant get the battery out.
remove seat. remove tool case. Remove terminals from battery, lift out.
take the terminals off and take the battery out and replace it \
Changing the battery on a Mazda 6 is very easy to do. You will first need to remove the bar that is over the battery, then you will need to remove the battery terminals. After the battery is removed, put the new one in and put the battery terminals back in place, and put the bar back on.
Remove the ground or negative cable first when disconnecting your car battery.
Remove the negative cable first and when installing the new battery connect the negative last.
Very simple. Just unscrew the bolts on the two terminals, pull it out, remove the battery and after replacing the battery, reconnect the terminals one at a time and tighten the bolts on the terminal.
It is very easy to change the battery in a 2004 Ford Escape. You will need to remove the bar that is covering the battery first. Then you will just need to take the battery terminals off the battery and then remove the old battery. Put the new battery in and put the terminals back on in the correct order. Then put the bar back over the battery and it is ready to go.
Remove the negative terminal first and connect it back last.
I would suspect the battery has been discharged, is defective, or you have loose or corroded battery terminals. Remove and clean the terminals and if that does not solve the problem charge the battery with a battery charger. If it will not take a charge then replace the battery.
Yes, baking soda can be used to clean battery terminals. Mixing baking soda with water to create a paste, then using a brush to scrub the terminals can help to remove corrosion and residue. It's important to disconnect the battery before cleaning and ensure the terminals are completely dry before reconnecting.
this is actually a very simple task. remove the bolts that hold the terminals on. slide them off and clean them with a wire brush. remove the nut that holds the metal bar that holds the battery in place. replace the battery. replace the nut, tighten it. replace the terminals and tighten them.