Hi there, I just took the plunge the other night and started pulling... The top center piece is the only one without a screw it has about 5 pop clips along it, the 2 side parts have 1 screw which becomes visible when you get the top piece off and a few pop clips.... Ps The clips work well
How to remove Window Winder Handles from VZ Holden Commodore
remove plastic moulding around door handle and door lock. unscrew door handle and unsnap plastic anchors around lower portion of door unscrew door panel from door. lift up on panel and remove. remove plastic. unscrew motor from door , let window down and remove two screws holding window. remove motor and metal bar replace and reverse process. 1991 Nissan maxima
To remove the door panel on the Holden Astra, first pop off the light lens if the door has a light in the door. Then unhook the light from connector. Remove the screws holding on the armrest, door handle, and window crank if equipped.
I'm using plastic protractor at my car window and its working.
http://forums.justcommodores.com.au/holden-commodore-how-s/5541-removing-vt-vx-door-trim.html
Remove the inside door panel and see what has happened. Only then will you know the problem.
Roll the window down. Remove screw at the top front of the door,remove the two plastic screw covers on the grabbar and remove the two screws found there remove the screw in the door handle NOW is the time to Panic use a putty knife or large bladed screwdriver pry the bottom of the panel off CAREFULLY remove,pry it, the plastic piece from around the electric window control pull up the window controls and disconnect them also the electric door mechanism.Now continue to remove the panel lifting up as you remove it.
You need to unscrew the plastic of the door and remove the plastic handle then get the window low you will see 2 plastic screw, unscrew and then you have to pull up the window with your hands. It's very easy.... :)
The bracket snaps on the window over the plastic pin in the window. You need to pull the bracket away from the window to get it down and over the plastic pin. If you will be replacing the window regulator you can just cut the bracket where it snaps over the pin.
In order to replace the electric window motors on a Pontiac Grand Prix you will need to unscrew the Torx screws on the door, life it back to remove the plastic pieces. Remove all connectors, and the plastic covers.
First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.
If it is the kind of plastic clips that snap together around the edge of the window to keep it in the window guide, then they are only a few dollars at any parts store.