0
How do you remove rear light assembly for high Brake Lights on Ford Fiesta?
Wiki User
∙ 13y ago
undo 2 screws on outside edge,then reach through hole at rear from inside boot,and unscrew plastic collar.
For those with newer models, this answer is still valid. I first saw this question
How do you replace the brake light bulb in an 2006 ford fiesta?
But my car which is 2006 still has the plastic collar to unscrew.
To change the 'High Level' brake light bulb - the one over the back window - open the hatch and remove the two rubber grommets from behind the light unit. Insert a flat screwdriver blade into each hole, push down the spring clip, and the light unit will come out. Try not to damage the screen washer pipe attached to it. The bulb is an 18w wedge-fitting.
Er... It isn't 18w, it's 16w. I didn't have my reading glasses on.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why do your Ford Fiesta brake lights stay on?
Adjust the brake switch which is above the brake pedal.
Why does your fiesta lights come on when you brake?
And 'appen the brake lights come on when you switch on the side lights? Someone has swopped the wiring over... or forced the bulbs into the sockets the wrong way 'round!
How do you change the brake lights on a 2002 Mitsubishi Eclipse?
You must open the hatch, remove the plastic strips then you must unbolt the tail lamp assembly and remove the bulb.
How do you replace a rear wheel bearing 2001 Prius?
Remove tire, remove brake drum, remove brake assembly housing, remove 4 bolts from back of hub assembly, gently tap to remove hub/bearing assembly.
How do you disassemble the rear brake light cover so you can replace the brake light bulb on an '94 Mazda Truck?
You must remove the entire light assembly as follows: Lower the tail gate and remove the two small screws that screw into the side of the assembly. Next remove the two screws on the outside of the assembly that are accessible through long holes on the outside of the assembly. Pull the assembly back to expose the rear where the lights are located.
Help with brake lights on 96 GMC jimmy?
The brake lights on a 96 Jimmy are operated by the brake light switch, mounted on the brake pedal assembly. If the switch is bad the lights could stay on or off, or be sporadic.
When the brake lights come on why do the side lights come on in a Ford Fiesta mark 4?
mines dun this it was wen a replaced the rear brake lights it was dogy bulbs put new wans in n it was sorted
How do you change brake lights on a 2001 Saturn SC2?
there are two small torx bolts on the inside of the trunk that i believe will make it possible to remove the light assembly
How do you replace wheel hub assembly on Chevy S 10?
Remove hub cap, remove axle nut, raise and support front of vehicle, remove wheel, remove brake caliper and brake pads, remove caliper bracket, remove brake rotor, remove the three 15mm hex head bolts holding hub assembly to knuckle, remove hub assembly by tapping flange with a bfh. Reverse for assembly.
How do you change the brake lights in a 1999 Chrysler lhs?
Pull back the carpet and remove the 2 plastic "wing nuts". This will allow the entire taillight assembly to hang loose. Remove the bulb assembly by turning it 1/4 turn and replace the bulb.
How do you remove rotors on a 2000 camaro v6?
remove wheel. remove brake caliper assembly(not the brake hose) and pull off the rotor.
How do you remove a rear hub assembly on a 97 avenger?
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
