To begin, you locate a speaker which you want to remove, and grease the sides around the desired speaker. Then, using an exact-o knife, you want to go around the edges of the speaker carefully. Once it seems that you have loosened it enough, use a butter-knife, or a more suitable tool, to pop it out of the socket. There will be several wires still attached to the speaker. Take them all out of speaker, one by one, and wrap the ends in electrical tape. You must leave the wires in the car though, or else the radio will not work. You can cover the gap where the speakers used to be with a sheet of plastic, and glue it down using basic extra-strength glue. Apply the same to the other speaker. These instructions are based on if you do not have car-mechanics equipment.
1994 Toyota corolla
Open the hood of the engine compartment to your 1994 Toyota Corolla. Remove the wiring harness from the headlight. Remove the headlight retraining bolts from the headlight assembly. Reverse the process to install the new headlight.
YES coz i have a Toyota Corolla Sedan 1994.
where is the crank sensor for 1994 toyota corolla 1.6 ltr
To test the igniter on a 1994 Toyota Corolla remove the ignitor for the distributor. Using an ohmmeter check to see if it reads the proper voltage. If there is to little replace the unit.
yes they are the same cars from 1992 to 1997
To replace a wiper motor on a 1994 Toyota Corolla, remove the rubber stopper that cover the hardware attached to the wiper arms. Then grab the wiper arm and jiggle it back and forth until it comes off. Remove the old one and slip the new one on.
4.275m See http://www.cars-directory.net/specs/toyota/corolla/1994_5/2387/
asdasfasd
The timing marks on a 1994 Toyota Corolla are located on the crankshaft cover. The crankshaft cover is usually located at the very bottom of an engine.
Yes, they do have those.
No