In order to remove the screws that secure the rear speakers, you need a 7/32" socket and socket wrench. The wiring harness I have yet to figure out how to remove from the backs of the speakers lol.
Remove the mesh grille from the speakers, they just pop out. The screws holding the speakers in will then be exposed. Remove these screws and take speakers out.
there is no oil pressure in my 1997 ford taurus, but the oil is full?
The front speakers in a 1997 Ford Taurus measure 6 inches by 8 inches and are located in the front doors. The rear speakers are located in the rear doors and measure 6 inches by 8 inches.
were is the shift module on a 1997 Ford Taurus
Begin by removing the cable from the bottom of your 1997 Ford Taurus antenna. Remove the antenna retaining nuts. Reverse the process to install your new antenna.
If the starter bolts are difficult to remove on a 1997 Ford Taurus, they were probably put on using an air wrench. An air wrench can be used to remove them or a product called Liquid Wrench.
there it is http://mywiperblades.com/1997-ford-taurus-wipers.htm
The speakers in the front door of a 96 Ford Taurus are 6 inches x 8 inches. The speakers in the rear deck aer also 6 inches x 8 inches.
In a 2005 Taurus/Sable, all 4 speakers are 6x8's. not 6x9's or 6.5's
as long as you have an the sAME TRANSMISSIONS THEY WILL BE INTGERCHANGABLE.
I believe that the back speakers are 6x9, but the fronts are 6x8.
Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus