im going to guess you havent removed the seats yet so ill start there. recently replaced on my 96 highline and my 98 sport (acr) First: pull up rear seat cushion and set aside. Second: remove the torx bolts that hold the seatbelt buckles to the car. these also hold the seat back in place. Third: lift up on rear seatback and remove from car. Next: now you can reach the rear deck pad (carpet). this is easiest to remove from shelf when side seatbelts are fully extended. pop out seatbelt guides and slide carpet along seatbelt webbing and into trunk. congrats you can now remove the speakers. there are 4 screws per rear speaker. i suggest using factory screws to install aftermarket speakers. all neons use 6x9 speakers for rear. be sure to use speakers rated 180w peak or better. else youll have to replace again soon. installation is reverse of removal. est time for project 1h30m. due to rusted bolts. be sure to reinstall carpet window side first, seatback must "hook" into car b4 bolting in and be sure to tighten seatbelt bolts fully. theres no bolts for seat cushion. hope this helps.
6.5 for the front
If your talking about the door speakers then you will have to remove the door panels to get to the speakers.
front dash tweeters- 3.25" door speakers- 6.5" rear deck speakers- 6x9"
For a 1998 Dodge Ram 1500 extended cab, there are two different sizes of speakers. The front speakers are 6x9 and the rear are 5-1/4.
6x9's front doors and 5.25" in the rear
Remove the dash!
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
6 3/4 or 6 1/1
To remove the spare tire on the 1998 Dodge Ram, you will need a hex tool. Apparently no tools came with the vehicle to do this, so you may end up purchasing this tool. Better yet, take it to a Dodge dealership and they can remove it for you.
Does anyone know how to take off a radiator fan clutch from a 1998 Dodge Dakota 3.9 V6
In the rear luggage area, remove the carpet, - remove the folding table - it is stored underneath.
If its anyhting like my wife's 2000 - you have to remove the rear seat to gain access to the grill/speaker area. There is a latch you pull outward which is located towards the center of the rear bottom seat to remove the bottom. Then you see the bolts to remove the seat back. You might have to remove some trim pieces as well. then remove the carpet covering the speakers.