Want this question answered?
For the front turn signal on a Chevy S-10 you remove the parking lamp lenses and replace the bulbs. If it is a rear turn signal bulb the taillight lenses will have to be removed to access the bulb.
blown bulb...doh !
Remove the turn signal light bulb connector. Take hold of the light bulb, push in and turn at the same time, to remove the light bulb. Reverse the process to install the new light bulb.
Answer : unscrew the signal lens and remove the signal bulb and replace with 1157 bulb reverse process
If its the front turn signal you open your hood and partly remove the black plastic cover on top of your headlights. Then you should see a screw on that screws on your signal light. Remove the screw and take off the the signal light and then remove the bulb.
If it is a front bulb, sometimes you can get to the bulb and remove it by turning it counterclockwise. If it is the rear you have to remove the housing and then remove the bulb. Remove the (4) 7mm Hex screws that fasten the wheel well liner. Pull the liner back as needed. Then reach in and remove the bulb by twisting the connector to release the connector and bulb from the turn signal housing. Pull the connector back towards you and replace the bulb.
behind assembly, bulb is connected with electrical clip, remove clip turn bulb counter clockwise and remove. easy as tHAT. See sources and related links below for bulb information.
1996 Isuzu Trooper turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Remove the headlight assembly above the bad bulb to gain access to the burned out bulb. To remove the headlight assembly, open the hood, locate and remove the two tabs that lock and hold the assembly in place, with those tabs removed you can wiggle the headlight assembly out in the open. Now you can reach in and r & r the burned out signal bulb
that's a lot of turn signal bulbs, are you sure you need to do 2006 of them?
On the 1998 Audi A6, the turn signal bulb can be replaced by opening the hood. Reach into the turn signal from the fender wall and push in and turn the old bulb to remove it. Push in and turn to replace with a new bulb.
By popping the light cover off and then figure out in your owners manuel how to remove the the bulb.