If yours has disc brakes, remove the caliper mounting bolts and move the caliper out the way. Remove the hub nut assembly and withdraw the disc.
Separate the disc from its carrier and hammer out the studs from the front.
wheel studs? head studs?
do you want to remove the actual studs or remove the lug nuts? the lug nuts may have left hand thread which means they go clockwise to loosen if you mean remove actual studs, u need to remove wheel. the studs will knock out with a hammer. you will need to replace with new ones
Lug studs on a 1994 Acura Integra is pressed into the hub. To remove the lug studs safely raise and prop the car. Remove the wheel, brake components, and suspension parts from the hub. Press out the old studs.
you have to remove the studs, or remove the entire intake manifold! when you do finally get it off replace the studs with bolts.
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
To remove wheel studs from a 2000 Honda Civic the wheel needs to be removed. Taking the wheel hub completely off the vehicle makes the process of removing the studs easier. The studs are pressed in and use of a machine press to remove them is recommended.
You can remove the wheel studs, on your 1992 Chevrolet alumina, by pounding on each one with a sledgehammer. You will want to make sure not to round the edges.
NO not at all just dont cut your studs out
No, they are made to come out when ice goes.
it is probably just rusted to the studs, hit it with a hammer until it breaks loose be careful not to hit the studs
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
to put studs in a track just simply remove the six bolts on the tunnel and the suspension will drop. then remove the cog wheel under the tunnel and then the track will finally drop out. then make a stud template and mark the holes where u want the studs to go. then drill the track, put the studs in from the inside and then the backers and the nuts goes on the outside. and there is your studded track