Want this question answered?
Lucky you. Remove the back seat cushion and remove the maintenance cover. However... To remove the seat cushion, you need to remove the seat backs first. *DO NOT* try to pop the seat cushion off its hooks at the front. You will wreck the cushion and its hooks. Once the seat backs have been removed, you can undo the single bolt at the middle-back of the cushion, at which point the cushion pivots up and forwards to disengage the hooks.
* Working at the front of each seat cushion push the retaining tabs in then lift up on the front edge of the cushion and release the seat cushion retaining tabs. Remove the cushion from cushion from the vehicle * Detach the retaining bolts at the lower edge of the seat back * Lift up on the lower edge of the seat back and remove it from the car
The battery is under the rear seat cushion. # Push in and up on the front of the rear seat cushion. # Lift up and out on the seat cushion. # Remove the rear seat cushion from the vehicle
* Remove the seat cushion by pulling out on the retainer then pull up sharply on the cushion.After removing the cushion remove the bolts and lift the seat back out
Removing the back seat in the Kia Rio is simple. Remove the screws or bolts from the lower cushion and remove cushion. Then remove the now visible screws and remove the remaining parts.
* On fixed seats remove the bolts at base of the seat back sidecushions and detach them.Remove the two bolts at the rear of the seat cushion and detach the cushion assembly.Remove the two bolts at the base and remove the seat back * On folding seats remove the two bolts at the front of the seat cushions and detach the cushion assembly.Fold the seat backs forward remove the bolts and lift the assembly out
under rear seat cushion there are fuses you can remove pass side push on seat lift up cushion
1.On fixed seats,remove the bolst at base of the seat back side cushons and detach them.Remove the two bolts at the rear of the seat cushion and detach the cushion assembly.Remove the two bolts at the base and remove the seat backs. 2.On folding seats,remove the two bolts at the front of the seat cushions and detach the cushion assembly.Fold the seat backs forward,remove the bolts and lift the assembly out.
the easy way is to un clip the seat the clip is located under the front seat cushion by filcking the wire clip back its a wire clip lift cushion off then there are four bolts which unbolts seat to frame you will need to unplug wiring for seat motor you will see when you remove cushion then lift seat out
Reach down in the bite-line (where the seat cushion and the seat back meet). Pull up on the seat cushion until the cushion raises above the bottom of the seat back. Pull the seat cushion towards the front. There are two metal tabs that are hooked into the front of the seat cushion that holds it in place; unhook these by moving the cushion forward. To replace, reverse the procedure, but make sure the seatbelt recepticles are exposed before pushing the seat cushion down into the bite-line.
The rear seat cushion on a 2003 Honda Civic is held on by mounting bolts. Push the seat down to reveal the mounting bolts for the seat. Loosen and remove them. Lift the seat up and out of the cabin of the car.
1993 kawasaki voyager motorcycle how do you remove the driver seat?