If it is the same as the '85 or '86 models, you will see 1 bolt on each side of the lower part of the seat, they could be the adjuster bolts for the seat to slide forward or back, towards the back of the seat, need an Allen key for this, remove them, the seat will slide either forward or back, ( cannot remember ) Once you slide the seat, it will release from the clip underneath the seat. If you do have no success this way, with the 2 rear bolts removed, peel up the front part of the seat, on the side, you will see on each side 1 bolt, us a wretch and remove them. Should do the job.
If it is the same as the'84 to '87's then 2 bolts in the back of the seat ( passenger seat ) each side, with Allan key, remove, then slide seat I believe forward to release the catch that's under the seat.
how do you remove the gas tank on a 1983 goldwing
Answering "Can you remove one carburetor from a 1983 gl11oo goldwing without removing all four?"no screws hold carb to airbox access from inside air box
Remove the seat and the top compartment. It's under the air filter.
Left side of the bike. Remove plastic cover just below seat.
Left hand side. Remove the plastic panel that is below the seat on the side of the bike.
remove battery cable remove gear change lever remove two bolts thru starter then work it out .' that's it
Using the correct size Allen wrench, remove the passenger handles on each side of the bike. Then, lift the rear of the seat up and pull rearwards after it clears the passenger backrest.
Left hand side below the seat. Remove the plastic panel to access the battery.
There are 2 Allen key bolts at the rear of the seat. One on each side, just above the shocks. Remove them, then push the seat forward so that it will slide out of the clip under the front of the seat. If you cannot slide the seat, then there are 2 more bolts around the middle of the seat tucked up a little. Then remove them.
Have to remove the engine for this job. Takes anywhere fron 10 to 15 hours for the job. The part cost is from $ 150.00 to $ 250.00.
The 1200 and 1500 had a seat height of 30.7" until 1995. They lowered the seat height to 29.1" in 1995.