0
How do you remove side marker light assembly on an Oldsmobile silhouette?
Wiki User
∙ 11y ago
On my 99 you remove the headlight assembly by removing the two plastic covered wing nuts, then remove the side marker/blinker assembly by removing the plastic covered wing bolt, then the light is accessible. It sounds harder than it is!
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the horn and how do you access it on a 1997 Oldsmobile Silhouette?
There are 2 horns on the 1997 Oldsmobile Silhouette. You must remove the headlight/ turn signal assemblies (2 thumbsrews to remove each one). You will find each horn in the space below the headlight.
How do you install front wheel bearings on 2001 Oldsmobile silhouette?
Remove tire, install spare which has an open center hole allowing access to axle nut, remove axle nut (33mm socket), remove spare, remove caliper, remove rotor, remove hub/bearing assembly, install new hub/bearing assembly, and so on in reverse order.
How do you remove the lens cover off a 1998 Oldsmobile silhouette?
If you're talking about a headlight lens, as far as I know you can't it's glued together to prevent moisture from entering the assembly. A new assembly is only about $30. on E-Bay or discountbodyparts.com.
How do you replace the front turn signal bulb in a 1999 Oldsmobile Silhouette?
you have to remove the whole headlamp assembly to get to the turn signal bulb pull the headlight assembly straight out it is fairly easy There are two wing nuts on top of the unit that must be removed.
How do you reset the computer on a 1995 Oldsmobile silhouette?
To restart your computer simply remove the positive terminal from the battery for 5 minutes.
How do you replace front marker light on 2006 KIA sorrento?
3 10mm bolts hold on the headlight assembly. Remove bolts and lift assembly slightly from the bottom to release it. Pull assembly forward. Twist marker light holder to remove it. Bulb pulls out. Reverse for installation.
How do you remove an Oldsmobile silhouette armrest?
Unzip the armrest cover and pull forward. You will the see the bolt that holds the armrest onto the seat.
How do you change marker lights 1995 bronco?
Remove the two bolts that hold the whole trim assembly together. Remove the outer trim and turn signal and then the marker lights to change them.
How to change side marker bulbs 2000 Ford Crown Victoria?
Front marker lights can be changed by removing front headlight assembly. To remove pull up on two metal clips behind light assembly and unplug wires. The side marker lights are now accessable. Turn bulb socket ccw to remove.
Where is the computer located in a 1997 Oldsmobile silhouette?
The 1997 Oldsmobile computer is located behind the passenger side kick plate. You will need to remove the passenger side kick plate in order to access the computer.
How do you replace the headlight bulb located on a 1994 Lexus LS 400?
You need to remove the side marker first. Remove the screw and pull hard perpendicular to the car to remove the side marker. Once that's removed you can see 2 screws on bottom of the headlight/foglight assembly and one screw on the top of the assembly as well as one nut on the side of the light assembly. Remove those screws and nut and you can pull out the whole headlight/foglight assembly. Remove the connector by pulling it straight out. Remove the rubber gasket and the spring lock. Assembly is the opposite.
How do you change the thermostat in a 2001 Oldsmobile silhouette mini van?
information you can find all says to remove the crossover pipe, but i have found it is much easier to remove the throttle body instead.
