Want this question answered?
It is in the valve cover.
no its not
The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.
On my 2000 montero sport, the horn is behind the driver side on the bottom plastic griill below the bumper. From the front take out three screws for access. Reach behind with box end wrench to unbolt the horn and remove. It's elcetric plug has latch to remove.
right front valve cover open the hood and on the drivers side valve cover in the front you will see it
the crank sensor is located behind the main accessory drive pulley which is installed at the end of the crankshaft you have to remove the pulley and the plastic cover that covers the timing belt
The fuse box diagram for a 1986 Mitsubishi Montero is found through a factory service manual. The underneath cover of the fuse box also has each individual fuse labeled as per their function.
Replacing spark plugs is pretty simple. Disconnect the battery, remove the cover and cables, remove the old spark plugs, put in the new spark plugs, put the cover and wires back on the spark plugs, and reconnect the battery.
The Montero Sport's tailgate dome light doubles as the switch. The entire clear plastic cover slides left to right and has three positions. ON-DOOR-OFF
grundle
sounds like the water pump is leaking
There aren't headlight covers, it all one unit. One of my lens was cracked and I had to replace the whole unit.