0
How do you remove spare wheel on 2008 previa mine seems to have strange nut holding it in place?
Wiki User
∙ 14y ago
There was no 2008 Previa made. Production on the Toyota Previa ended in 1997. On 1997 and older models, the bolt for dropping the spare tire can be found underneath the edge of the carpet in center of inside after opening tail gate. Look for what appears to be slight cut in carpet starting at rear and going forward. The bolt holding the spare tire can be found there. Use appropriate socket wrench or 4 way lug wrench to remove bolt.
Do not have feet or other body parts underneath spare tire as when bolt releases spare could hit them.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Toyota Previa fuse box?
Toyota Previa fuse box is located underneath center console. It has a latch mechanism holding it in place at front of console but can be pried up with flat edge screw driver.
How do you remove a headlight on a Ford Transit Connect?
Remove the bolt holding it in Place
How to change brake pads on 1994 Nissan Sentra?
First remove the Tire, then Remove the 2 bolts holding the Caliper on to the rotor slide the caliper up and remove the 2 tension springs holding the Pads in place.
How do you remove headlight on a 1990 Porsche 911?
remoce one screw holding the trim ring on then the four behind it holding the housing in place
How to replace side mirror on 96 quest?
You have to remove door panel to get access to the screws holding the inside plastic cover in place. Remove the plastic cover and then the three nuts holding the mirror.
How do you remove the spare tire on a 2002 ford ranger?
You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward. You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward.
How do you replace the heater blower resistor on a Toyota Previa?
Raise the hood, remove the inlet shroud to the blower housing, then remove the top half of the radiator fan shroud. Next start removing the screws that hold a protective cover that is below the blower motor. There are 4 screws and one bolt that secure this. Let this cover drop down and then the blower resistor can be seen behind the blower motor. Remove the electrical connection plug and then the two screws that hold the resistor in place. Go to this site for great Previa info: http://autos.groups.yahoo.com/group/previa/
How do you remove the crankshaft sensor from a 1998 Chevrolet Blazer?
Unplug the electrical connection at the sensor. Remove the small bolt and retainer holding the sensor in place. Remove the sensor.
How do you remove and to replace starter?
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
How do you remove the dead pedal from a '99 Honda prelude automatic?
There are bolts holding the dead pedal in place. Remove those and it should come off.
How do you remove rear fender?
The procedure differs depending on the year and model, but basically you remove the wheel, disconnect any wiring and remove all fasteners holding the fender in place.
How do you remove Avalon front seat motor?
ermove the bolts holding the seat down. unplug wires going to seat. turn seat over. remove bolts holding motor in place. reverse prcess to install
