Try WD40
Sulfur
you can easily remove iron with magnet. then if you do not care about the sulfur you can set it on fire, and what is left will be pure sand. If you do care about sulfur i don't think i can help you.
A mixture of iron and sulfur can be separated using a magnet- the iron will be attracted to the magnet, sulfur will not. Not the that the iron could be coated with sulfur powder so an extra step is required to remove it.
True
calcium oxide is injected into the final stage of the scubber, wich then reacts with the sulfur dioxide to form calcium sulfite.
Sulphuric acid rain due to air pollution
Sulfur
Sulfur
chromatography
Avoid putting sulfur into the air. This can be done by burning low sulfur coal, or by using scrubbers to remove the sulfur from the exhaust. Also use ultra low sulfur diesel fuel.
you can easily remove iron with magnet. then if you do not care about the sulfur you can set it on fire, and what is left will be pure sand. If you do care about sulfur i don't think i can help you.
Catalistic converter??
Basically, sulfur dioxide is a acidic gas. As acid reacts with alkali, carbonates and metals, all 3 are actually ideal to remove sulfur dioxide. However, in the context of removing sulfur dioxide due to air pollution, reacting sulfur dioxide with alkali and carbonate would be more appropriate. For example, removing sulfur dioxide with calcium carbonate would result in calcium sulfate, water and carbon dioxide.
A mixture of iron and sulfur can be separated using a magnet- the iron will be attracted to the magnet, sulfur will not. Not the that the iron could be coated with sulfur powder so an extra step is required to remove it.
Simply heating (warming) sulfur could be a physical change if nothing happens to the sulfur other than it just getting warmer, and when you remove the heat, it stays as the original sulfur. However, more likely than not, heating sulfur will cause a CHEMICAL change where the sulfur combusts and turns into sulfur dioxide (SO2).
Remove any attachments from the faucet to use the acid, such as aerators or screens. Rub the cleaner onto the affected area and rinse with hot water. Repeat if necessary1 Apply Scour Off Paste to a sponge and gently scrub the sponge around the rib of the faucet. Rinse with water and remove all paste cleaner. Dry faucet fixture with a towel. Repeat if necessary. Use a drain cleaner. Mix vinegar and hot water into equal quantities and pour the mixture into the drain. Leave it for hours and repeat the process 3-4 times. Fill a clean, new trash can about 1/3 full and put in a gallon of bleach. Turn off the water to the house. Connect the pump to an outdoor hose bib and run cold water until you can smell bleach. Turn the pump off and let the bleach solution set for a few hours. Dump one-fourth of a cup of baking soda followed by one-fourth cup of white vinegar into the drain. Let it bubble for ten minutes. Heat up a pot of water and pour the high-temperature water into the drain.
True