answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove sump off opel frontera 2.2 diesel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Were is the sump plug on astra 1.7 diesel?

On 1998 year ,The sump plug is on the bottom of sump at the rear right.


What happens when diesel get into the engine sump?

it behave like a fuel


Where is the sump plug on 1.7 diesel corsa van?

under


What size is the copper washer on a Nissan Note diesel sump plug?

what is the size of a nissan terrano sump plug washer


What is the oil drain plug wrench like to Ford Fiesta 1999 diesel?

Sump drain plug is 13mm hexagon A 13mm 6 point socket will remove it.


How do you replace the oil sump sealant in your Toyota 2c engine?

How do you seal a leaking oil sump in 2c toyota diesel engine


Keep loosing oil pressure but if you turn veicle off and re start its ok for half hour or so any ideas thanks its a frontera sport 2 liter?

You have dirt in the sump which is being sucked up onto the filter and blocking the oil feed. When you turn off the engine, it drops back into the sump. Change the oil and filter. If big lumps drain from the sump, better to remove and clean out the sump. Then fit engine flush before new oil.


How do you changes a sump gasket on a Ford Fiesta 1998?

how easy is it to change a oil sump gasket on a ford fiesta 1.4 diesel 2008


How do you remove sump on x reg astra?

Remove the bolts.


Where is oil drain plug on a diesel escort 2000?

its at the back of the sump box


How do you change the alternator on the fiat doblo 1.9 diesel?

you dont need to remove drive shaft or remove engine mounts to change a alternator on a fiat doblo 1.9 diesel,ive just done one,remove dip stick,remove hoses into steering ram,get a scissor car jack,jack between sump & chassis only a little & alternator will slide out.


How do you remove the oil sump on a vw beetle?

Easy, put the car on ramps. Remove the sump guard plasctics. Drain the oil from the sump. Disconnect the oil level sensor wires. Undo the 3 bolts on the bell-housing that holds unto the sump, you will need a 5mm ball-end allen socket. Undo the 20, 10mm head bolts on the sump bottom. Remove the sump, you may need to tap with a soft-head hammer. This is one of the easiest sumps to remove with the engine in the car.