Want this question answered?
on the bottom of the sump!
Remove the bolts.
how do I remove the dash panel on a Vauxhall omega
Easy, put the car on ramps. Remove the sump guard plasctics. Drain the oil from the sump. Disconnect the oil level sensor wires. Undo the 3 bolts on the bell-housing that holds unto the sump, you will need a 5mm ball-end allen socket. Undo the 20, 10mm head bolts on the sump bottom. Remove the sump, you may need to tap with a soft-head hammer. This is one of the easiest sumps to remove with the engine in the car.
wash it
yes. you drain as much engine oil from them sump as you can by undoing the 13mm sump plug. you then undo all the bolts holding the sump onto the engine
if it is what i think it is there is a nut that you put a bolt in that pulls the sump down
Drain Engine oil Jack up and support car Remove front wheels Remove under pan Remove front inner wheel arches Remove sub frame side supports Remove front subframe Support cooling system with straps remove RH half shaft bearing support bolts Remove dip Stick Remove all sump to block bolts and sump to gearbox bolts.
Drain Engine oil Jack up and support car Remove front wheels Remove under pan Remove front inner wheel arches Remove sub frame side supports Remove front subframe Support cooling system with straps remove RH half shaft bearing support bolts Remove dip Stick Remove all sump to block bolts and sump to gearbox bolts.
i think as with all vectras it is a n.o 45 torx/star bit on the sump hope this helps
Remove nut from bottom of sump.
at the back of the sump, but first you must remove the car under tray, approx 8 torx screws