0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Will a 97 vitara bull bar fit a 93?
I've a 1997 Suzuki Vitara :)
How do you replace front wheel bearings on a 1997 suzuki vitara?
You will need to remove the tire and wheel from your 1997 Suzuki. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.
Does a 1997 Suzuki Vitara have an obdII plug?
Yes, under the steering wheel
How to open the bonnet of 1997 suzuki vitara.?
Open the glove box and you will find the lever.Pull it and hey presto
How do you replace a blower motor on a 1997 Bonneville?
The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.
How do you remove glovebox on mondeo 2001?
Hope this helps. On a Mk2 1997 Mondeo, open the glove till it rests on stops and pull at approx 45 degrees towards you. The axle for the glovebox is set in a groove with stops which stop you accidentally removing the glovebox. If you are not sure, shine a torch by the side of the open glove box and you will see the runner and glovebox axle end.
How do you remove the dashboard on a 1997 Ford Thunderbird to replace the heater core?
you might be able to just go through the back of the glovebox to get to the heater core
Where is fusebox in 1997 ford mondeo?
under the glovebox
How do you remove the glove compartment in 1997 e 320?
Begin by first opening the glovebox and removing the light assembly at the top. Pry the right side of the light assembly downward and it will pop out. Disconnect the connector going to the light and set it aside. Now you'll need to remove the glovebox. The glovebox is held in place by six Phillips head screws, two on the top edge of the glovebox under the dashboard trim, two along the bottom edge of the glovebox under two rubber caps and two hidden up underneath the top edge on either side of the light. You'll need to remove the rubber caps along the bottom edge of the glovebox. Just pop them out with a screwdriver. Once all the screws have been removed, give the glovebox a firm tug towards you to remove it from the dashboard. For a detailed explanation with pictures see the related link below.
Where is the tool compartment on a 1997 Suzuki 800?
On a 1997 Suzuki Intruder 800, the tool compartment is located in the sissy bar. Just remove the back rest cushion (it pops off) and use the key to open the compartment behind it.
Where is a suzuki 1997 sidekick distributor located?
Where is a suzuki 1997 sidekick distributor located?"
Where are Spark plugs located for 1997 Suzuki Marauder 800?
you will have to remove the gas tank and then remove the covers, located on each side near the front of the engine.
