answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you remove the ac compressor on a Mazda 3?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace an ac compressor on 1984 Chevy Celebrity?

To change out the ac compressor on your 1984 Chevy Celebrity: 1. If there is any freon or pressure left in the system you should have a professional empty the system. 2. Remove the hose off of the back of the compressor. Plug the openings to keep dirt out. 3. Loosen the adjusting bolt and slide the compressor over and remove the drive belt. 4. Remove the bolts and the compressor will come out. Reverse the procedure to reinstall the compressor unit.


How do you remove ac compressor for 1997 Pontiac firebird 3.8 engine?

u have to lift the car up and remove from the bottom of the car. and its held by 4 or 5 bolts 3 in the front and two in the back of the compressor.


What is the ac compressor oil capacity for a new ac compressor on a 1997 dodge ram 1500?

3 or 4 ounces.


How do you loosen the ac belt on a Mazda Mx3?

There's a bolt you need to loosen by the AC pump to loosen/remove the belt. Check www.mx-3.com there's an online manual available.


How do you replace the clutch on the ac compressor on a 1999 mercury villager?

generally u dont replace clutch as it is more prudent to just get a used compressor from junk yard. you will need a pair of snap ring pliers. 1. remove nut on compressor shaft and remove clutch plate. 2. remove snap ring holding pulley on compressor. 3. use two screwdrivers on opposite sides of pulley to help slide off pulley.


How much oil to put in a new ac compressor for a 1994 surburban 5.7l?

If you only replaced the compressor, 2 to 3 ounces.


How do you install AC compressor on a 1989 Bronco II?

1. Discharge the a/c system.... 2. Remove the drive belt... 3. Remove the a/c clutch wire pigtail... 4. Remove the a/c hose assembly.. 5. Remove the front and rear bolts... 6. Remove the compressor... 7. Reverse to install... 8. Evacuate and recharge... 9. Add the correct amount of freon and oil......


Can you use 3 split ac unit on one compressor unit?

Up to 2 forced air units to one compressor unit.


Why is your ac heater fan not working on your Mazda 3?

One reason why an AC heater fan will not work on a Mazda 3 is that the fan is burned out. It will have to be replaced. However, first check to make sure that you have not simply blown a fuse.


When replacing the AC compressor what is the oil capacity of the AC compressor for a 1995 Olds 88?

If the system didn't blow a hose and you are only replacing the compressor, I would add 3 ounces of oil to the new compressor through the suction port and turn the comp by hand several revolutions to pump it through.


How long goes it take to replace a ac unit in a 1996 z34 Monte Carlo?

Recover the freon, R&R the compressor, evacuate the system and recharge, aprox 3 hours assuming the ac unit you speak of is the compressor.


How much oil do you put in a new ac compressor on a 2003 grand caravan?

3 or 4 ounces.