To remove the air cleaner from a 1986 V6 Astro van, simply locate the filter box above the radiator and remove the cover by flipping both of the metal clips. you can now pull the filter out and insert a new one, using the arrows as a guideline to make sure that the filter is facing the correct way. Clip the metal tabs back into place and replace the cover.
You will have to unbolt and remove the engine access cover inside the passenger compartment. Then you can easily get to the air cleaner.
The 1997 Chevrolet Astro Van 02 sensor can be found attached to the outside of the air cleaner housing. The O2 sensor will be on the back side of the air cleaner housing.
Air Cleaner (Element) Removal & Installation1. Disconnect the negative battery cable. 2. Remove the outlet tube clamp from around the air cleaner element housing and remove the tube from the air cleaner housing. Position the tube out of the way. 3. Remove the air cleaner element from the air cleaner housing. 4. Installation is the reverse of removal.
It is under the air cleaner system, on the front of the engine.
Remove your air cleaner housing, left front tire. unplug and unbolt your alternator and remove it up throw the air cleaner area.
Top of engine under air cleaner
1 and it is located behind the air intake ...take off your air cleaner and casing..its behind there
The control module is located under the air cleaner box. Carefully remove the the upper air cleaner enclosure, MAF sensor and rubber duct. Remove air cleaner and lift compartment lid. Computer control module is there. Hope this helps?
The air filter is located in the air cleaner housing, on top of the engine. You will need to remove the air cleaner housing cover to access the air filter.
3.0L, you remove the air cleaner box to access.3.3L, you reach from underneath along the exhaust to access.3.0L, you remove the air cleaner box to access.3.3L, you reach from underneath along the exhaust to access.
Removal & Installation (4.6L & 5.4L) 1. Disconnect the negative battery cable. 2. Release the air cleaner clamp and separate the air cleaner halves. 3. Remove the grommet from the air cleaner housing and slide the grommet down the hardness. 4. Remove the (MAF) sensor plate and (MAF) sensor from the air cleaner. 5. Detach the (MAF) sensor from the harness. 6. Remove the retaining nuts and remove the (MAF) sensor. 7. Installation is the reverse of removal.
remove the air cleaner box it is underneath