Take it into a jeweler and they will have no problem removing it for a small fee.
Open hood , remove neg battery cable , remove intake hose , air filter box , remove throttle body and wires , water hoses that are connected to it , remove intake manifold , there are 2 sensors under the intake , one of them is the oil press switch , other one is the knock sensor , knock sensor is the one closest to the cylinder head
It is on the passager side beside the starter. First drain your cooling system and disconnect negative battery cable. Remove and reinstall the new one.
That engine has 2 of them and you MUST remove the intake manifold to service the knock sensors.
Disconnect the negative battery cable.Drain the engine coolant into a suitable container.Unplug the sensor connector.Using the proper size socket, loosen and remove the knock sensor.To install:Carefully thread the sensor into the engine block.Tighten the sensor.Attach the sensor connector.Refill the engine coolant.Connect the negative battery cable.
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
that the knock sensor does
you have to remove the intake, and there are 2 knock sensors.
how do you change the knock sensor in a 2003 Chevy silverado 5.3
where is the knock sensor located on 93 cutlass ciera
In order to change either or both of the Knock Sensors, you must first remove the wire connections. The sensors are physically located directly underneath the intake plenum. You will need a metal tool to remove the fuel lines also. Needle nose pliers may be needed to extract them. You will need to use some sort of sealant on the new sensors.
YES you do have to remove it all the way. There are 2 knock sensors under the intake.
how much does it cost for labor to change a knock sensor in a 2002 toyota siennna van