push in on both sides of the rear seat bottom and lift up to get the bottom of the seat out and the back is held in with 2 bolts that go through the floor pan, take the bolts out and slide the back part up to get it out.
how do you remove the back seat in the 2003 poniac grand am
the back of the seat is the front of the trunk. To remove the rear seat back you first have to remove the two bolts just under bottom seat assembly. Bolts are located at the botton of lower seat, about between your ankles if you were sitting in the seat, one on each side. Then remove bottom seat assembly. Then remove seatbelt bolts that hold seat back assembly, lift straight up on seat back and remove.
There are 2 bolts on the bottom part of the seat, they are a 13mm if i remember right. Remove those two bolts, pull the seat bottom out, remove the two Torx bolts that hold in the seat belts. Push the seat up to unhook it and pull back and the seat back will come off.
Below the seat at floor level, there are two bolts hidden under the edge of the seat. Once you remove them, the seat simply lifts out. Then removing the seat belt bolts and pulling up on the back rest removes it...
Look under the front of the back seat, you will see 2 large bolts. Remove those and the seat bottom will pull straight out. Now you will see 2 bolts under the seat back, remove those, then lift up the seat back and it should come free. That's it.
There are mounted bolts that secure the seat to the chassis. Locate all the mounted bolts and remove them. Then pull the seat forward out of the vehicle.
It's under the back seat. Pull up on the front edge of the back seat to remove it.
Your battery is located under you back seat. You have to remove the bottom section of your back seat before you can change it. After you remove the seat if you take it to a local automotive store and purchase a battery, they usually will change them for free.
you need lots of tools to do that then take it out carefully
there are two T- handles, one under each side of the bottom of the seat.. tug them and lift the seat off. Then there are two ( i think) bolts at the bottom and 4 at the top that remove the rear or back portion of the seat off.
Push on the lower end of the seat to unclip holders (takes a lot of pressure) After unclipped slide forward to remove bench You will then see clips or bolts holding the back of the seat remove/release these and slide back up to release upper clips
* Unlatch the rear seat back and tilt forward * Unhook the outer side belt retractor from the rear seat back * Remove the spacer from the right key pin * Slide the seat back to the right and disengage the left key pin from the left key slot * Slide the seat back to the left and disengage the right key slot from the right key slot * Remove the seat back * Press the seat cushion retainer to the rear with a screwdriver * Lift the seat cushion up and remove it